How many times have you seen a model with pins in to stop the hinges pulling out that have been done after covering. Many people have asked others why they don't pin their hinges, well, we do pin them, but before we cover the model, here the way to do it.
Here's How
1. First fit the hinges into the elevator and then pin them (We use cocktail sticks)
2. Cover the elevator
3. Cover the rear face of the tail plane where the hinges fit wraping over to the top and bottom of the tail plane by about 5mm
4. Fit the elevator to the tail plane and pin the hinges.
5. Cover the tail plane, (bottom first and then the top).
All done hinges hidden under covering, This also applies to ailerons and rudder.
Dubai RC Hobbies.